Falcon 12 - T2-76 Impregnated Core Bit - Standard

Conventional coring is a traditional method of taking samples from bottom-hole formations. This method is still the most commonly practiced method in the petroleum industry. The selection of conventional core bits Drill It provides are of the highest quality alloyed steel which allow for high penetration rate and a longer life for the bit. 

The T2-76 is built for a T2 Core barrel. The T2-76 is 76mm (3 Inches) wide and produces an inner core of 62mm (2.4 Inches) in dimeter. They are suitable for medium to hard geology. The T2 core barrels have a relatively small cutting area and therefore permit rapid penetration, especially in harder rock formations. The thin wall barrels and core bits produce fewer cuttings which permits the use of lower flush velocities, resulting in diminished sample disturbance. Water or polymer flush is required.

This bit is part of the Falcon 12 Series. The Falcon 12 is forged with the diamond very exposed from the bit matrix, meaning this series of Coring Bit is built for hard formations, making it more effective for drilling through rocks such as hard limestone, dolomite, andesite, marble and magnetite.

Drill-Its Falcon set of drill bits are our range of standard conventional coring tools, meaning it they use Core Barrel Drill-Line Inner Tube Plastic Liner consisting of a clear, thin-wall extruded rigid plastic tube of which by accurate manufacturing processes is manufactured to close tolerances on both the outside and the inside diameters. Clearance between the O.D. of the “Drill-Line'' and I.D. of the Core Barrel inner tube is therefore carefully controlled and allows easy fitting of the Plastic Tube into the inner tube in the field. When the clear plastic material is used (inserted) it will not contaminate the Core sample during drilling and encapsulation. The material does not absorb water and will not swell or change shape.